Ductless Mini-Splits in Newcastle, WA
Heating and cooling for Everett rooms that ducts never reached — one head or five on a single outdoor unit. The person who quotes it is the person who installs it.
A ductless mini-split installation puts an inverter heat pump outside and slim indoor heads in the rooms that need them, joined by a line set about three inches across. No ductwork, no torn-up ceilings. It heats and it cools, and in an Everett house that was never built with ducts it is usually the whole answer rather than a compromise.
ExactAir Home Comfort delivers expert ductless mini-splits to Newcastle, WA and throughout the Eastside. Rylan treats every Newcastle home with care — clear options, a licensed and insured owner-operator, and fast scheduling when you need us most.
Why Newcastle homeowners choose ExactAir for ductless mini-splits
Newcastle sees the classic Puget Sound pattern: months of cool, wet weather followed by genuine summer heat. We design and repair ductless mini-splits solutions that handle both ends of that range efficiently for Newcastle families.
Every Newcastle job comes with the ExactAir promise: open seven days a week from 7 AM to 8 PM, a fully insured, licensed owner-operator, transparent good/better/best pricing, and a 5% discount for active military, veterans, and first responders. We leave your home cleaner than we found it and walk you through everything before we go.
Our ductless mini-splits process
A ductless mini-split installation puts an inverter heat pump outside and slim indoor heads in the rooms that need them, joined by a line set about three inches across. No ductwork, no torn-up ceilings. It heats and it cools, and in an Everett house that was never built with ducts it is usually the whole answer rather than a compromise.
A straightforward ductless mini-splits process in Newcastle
Zone planning
I measure the house, run a load calculation, and settle how many heads it actually needs — and where each one goes.
Tidy installation
Line sets routed and sealed, outdoor unit level with proper clearances, deep vacuum and charge to specification.
Commissioning
Airflow and charge verified, each zone balanced, controls configured — then I show you how to run it.
Ductless Mini-Splits FAQs
An inverter heat pump outside connected to one or more wall-, ceiling-, or floor-mounted indoor heads by a refrigerant line set about three inches across — no ductwork required. Each head is controlled independently, so rooms can be set to different temperatures.
There is no single figure, because head count decides it and head count is decided by your house. One head for a bonus room and five heads on one outdoor unit are thousands of dollars apart. I price it after walking the house. A mechanical permit is pulled for the job and its fee is set by your local jurisdiction, so I confirm the current figure for Newcastle before it goes in the quote rather than guessing at it.
A head serves a volume of air that can circulate, not a room. An open-plan downstairs is often one head; three bedrooms with the doors shut at night is three. I settle it at the site visit, and I size the outdoor unit so a head can be added later if you want to stage the work.
Yes. Cold-climate inverter equipment holds usable heating capacity well below freezing, far below anything Newcastle sees. When comparing quotes, ask for the rated heating capacity at 17°F and 5°F for the specific outdoor unit proposed — it is on the manufacturer's data sheet.
They are among the quietest comfort systems made. An inverter compressor spends most of its life running slowly rather than cycling fully on and off, and running slowly is what makes it quiet — which matters here because the head is in the room with you rather than in a crawlspace.
No. If your house already has sound ductwork, a ducted heat pump is normally the better system — one filter, nothing on the walls, lower cost per square foot. Ductless wins where there are no usable ducts, and small-duct high-velocity is a third option worth considering in period houses where a wall head is not acceptable.
Most jobs run two to four days, decided by head count and how the building is put together rather than by the size of the equipment. I pull the mechanical permit myself, so the work is inspected.
Yes, every brand. The job most often skipped is cleaning the indoor coil and blower wheel — a head has only a thin mesh screen rather than a filter cabinet, so it loads with dust over the years, which is what causes the sour smell and the lost airflow.
Other HVAC services in Newcastle, WA
Ready to upgrade your home comfort in Newcastle?
Honest pricing, straight answers, and no high-pressure sales. Get your free quote from Rylan, the owner — the person who quotes your job is the person who installs it — plus a 5% discount for military, veterans & first responders.